Testing your blood glucose while running

I assume those reading my blog have no issue with blood. But just in case it freaks you out…

1. Don’t hang out with diabetics

2. Ignore the photo below.

Image

I’ve been keeping up with my Runner’s World Run Streak (running a minimum of 1 mile every day from American Thanksgiving to New Years).

Today’s run proved bloody. 

It was a “feels like -11 degrees celsius” morning. When I hit the road at about 8:30 a.m. all was well. I got enough sleep, ate the exact same breakfast and was ready to go. Nothing out of the ordinary.

On Thursday I had a bad hypo at 2.7 mmoL (48 mg/dl) in all likelihood to overestimating my dinner carb count. However on Friday morning I was at 16 mmoL (288 mg/dl) before my morning gym session after breakfast. I usually float between 4-8 mmoL, so this 16 out of no where was very surprising and since my control is super tight, it made me feel very very ill. Don’t think I’ve been 16 since I was diagnosed. I also start to get anxious when I see anything above 9 mmoL (which is rare). I hope that puts into perspective as to what the 16 was like for me. My pancreas seems to be on the fritz. Maybe the honeymoon is coming to an end?

So fast forward to this morning’s run. Before I started I was at 7 mmoL (126 mg/dl). Perfect, exactly where I typically need to be.

I checked about 40 minutes into my 12km run (7.46 miles) and my Bayer Contour USB meter said it was too cold to test. I get frustrated with this because my OneTouch Ultra Mini had no problem in the same temperature. With my gloves on I held my USB meter for about 2 minutes and tried to test again. Finally it worked and I lucked out with solid blood.

2.2 mmoL (39 mg/dl).

Problem is I felt fine. Luckily I was carrying a nice full roll of Lifesavers so I started scarfing down about 8 of them. When it came time to test 15 minutes later, I just couldn’t get the meter to read my blood. As you can see, I tried as many fingertips I could muster. The blood came out watery. I tried letting my fingers dry outside my glove (which made my hands cold but that doesn’t matter really unless it’s extremely cold to the point of danger). It still did little and the blood came out “watery”. Testing on the palm? Tried it, still watery. The gloves came off for 5 minutes before testing and the blood was still coming out “watery” and my meter said it wasn’t able to read it.

I find it a bit difficult to get a good system going when testing. I’ve been trying for months now to test smoothly while running and although I’ve gone out well over a hundred times, it’s still awkward. This is what I use:

Image

  • SpiBelt to carry all my glucose stuff
  • 1 container of test strips
  • Blood glucose tester
  • Finger pricker
  • 4 Dex4’s
  • Insulin pen
  • Granola bar

I’ve tried many belts and this one sits the best on me while I run. I find no difference in how I can handle testing while running with this belt compared to others so I opt for the comfort of the SpiBelt when I’m out on the road.

My routine: 

1. Turn belt so the pouch faces forward, unzip.

2. Take out strip container, grab one strip, hold in teeth, put container back.

3. Take out meter and place strip in appropriate slot.

4. Hold meter in left hand and take out pricker and use with right hand and stab self (usually left index finger).

5. Switch meter from left to right hand and try to gather blood.

I can’t tell you how many times I’ve dropped strips, had my meter go flying and just overall got so flustered by the process. When I’m running for time or with a group I don’t want testing to be such a chore, and so awkward. I practice testing on treadmills and out on the road but I’m still not getting it. It doesn’t feel right.

Image

Here’s what I need your expertise on: 

What is YOUR method for testing while running? What has made it easier for you? Faster?

How do you make sure your blood isn’t watery? Today left me frustrated and when the blood wouldn’t stop pouring out I just left it to air dry (which made a few people look twice as they ran past me). I really want to make testing while running a lot easier but seem to be stumped as to what to do.

Happy winter running and your help is much appreciated,

Jessie

Advertisements

3 Comments

  1. so much to say in a comment box!
    I used to put my meter and strips (in a Listerine mouth strip case) inside my glove when I ran. mildly annoying but it meant they stayed warm’ish.
    The cold temperatures can really cause the strips to misread the blod. My #’s always seem to read lower than they really are (in my experience any way, it may vary of course!). The cold will affect the meter as well as the strips. I found my meters wouldn’t really work much lower than 5C.
    I always had problems with my blood just going everywhere. Most of the time I wipe the first bit on my pants or whatever is black and not wet and test again with a better drop.

    those are my tips at least.

    Reply

    1. Thank you Scully. I’m going to try that. Listerine strip case, I would have never thought of using that 🙂 My next outdoor run is Thursday so I will give it a shot then. I also had no idea that the cold also misreads the strips. Great tips!

      Reply

  2. I see a lot of interesting articles on your website. You have to spend a lot of time writing, i know how to save you a lot of work, there
    is a tool that creates unique, google friendly articles in couple of seconds,
    just type in google – k2 unlimited content

    Reply

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s